Other problems, Data on the disk drive was not saved properly – Roland VS-890 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Troubleshooting

With о vídeo device os the master, the
VS-890 does not respond

• The cable connected to the L-connector, the SYSTEM E

connector or the MIDI cable is not properly connected.

• 1’he MIDI cable is broken.

• The SYNC MODE in the display indicates "EXT."

("Sync Source" is set to "INT").

• "Sy.sEX.Rx." (System Exclusive Receive Switch) is not set

to "On."

• "MMC" (MMC mode) is not set to "SLAVE."

• The MTC frame rate of the video device differs from that

of the S1-80SP (Roland Video MIDI Sync Interface), or the

video and the VS-890 are not set to the same type of

MTC.

• MTC reception is in poor condition.

Setting the Sync Error Level to "5" or higher may
improve conditions.

Other problems

Data on the disk drive was not saved
properly

• The VS-890's power was turned off without performing

the shutdown process.

• The power was turned off while the disk drive was

operating.

• A strong shock was applied to the disk drive.

• The disk drive or SCSI cable was connected or

disconnected while the power was still turned on.

Reinitialize the disk drive (and also execute physical
formatting) (Owner's Manual p. 134). Also, we
recommend that you execute Surface Scan as well
(Owner's Manual p. 135).