Roland VS-890 - Manual (Page 67)

Algorithm List
Voice Transformer
You can convert male voice into female voice, female voice into male voice, and human voice into mechanical
voice to CTeate sounds of various qualities by controlling the base pitch and the formant separately.
Input L
Output L
Reverb
Output R
* When inputting voice, use voice of one person only. Inputting voices of more than one person disables normal
operation.
* Be sure that sound from a speaker does not enter the microphone you are using. This will have the same effect
as if several voices were input to the unit.
* A undirectional microphone is recommended for use. It is also recommended that the person should speak
standing as close to the microphone as possible.
Parameter (full name) Setting Function
VT (Voice Transformer); Creates various voice characters.
VoiceTms (Switch) On, Off Turns Vocal the transformer on or off.
Robot (Robot) On, Off When this is on, the audio will be output at a fixed pitch
regardless of the pitch that is input.
C.Pitch (Chromatic Pitch) -12-+36 Sets the pitch variation of the voice to be output (by
semitone).
F.Pitch (Fine Pitch) -100-100 Sets the pitch variation of the voice to be output (by cent).
C.Formant (Chromatic Formant) -12-+12 Sets the formant variation of the voice to be output (by
semitone).
F.Formant (Rne Formant) -100“ +100 Sets the formant variation of the voice to be output (by
cent).
MixBal (Mix Balance) 0-100 Sets the volume balance between the output voice and the
input voice.
everb): Adds reverberation.
Reverb (Switch) On, Off Turns the reverb on or off.
Time (Reverb Time) 0.1-32.0 sec Sets the length (time) of the reverb sound.
PreDLY (Pre-Delay) 0-200 ms Sets the time until the reverberation appears.
Density (Density) 0-100 Sets the density of the reverb sound.
RevLevel (Effect Level). 0-100 Sets the volume of the reverb sound.
67