Roland VS-890 - Manual (Page 51)

Algorithm List
Parameter (full name) Setting Function
CLA, CLB
(Compressor):
(Limiter):
Compresses the entire output signais when the input volume has exceeded a
preset value.
Suppresses the volume of the section where the input volume has exceeded the
preset value.
Comp/Lmt (Switch) On, Off Turns the compressor/limiter on or off.
Detect (Detect In) A, B, Link Selects Input A or B for controlling compressor/limiter. Set
this to “Link” for controlling by the input at a greater level.
Level (Output Level) -60-12 dB Sets the volume of the compressor/limiter sound.
Thrsh (Threshold Level) -60 - 0 dB Sets the level at which the compressor/limiter starts taking
effect.
Attack (Attack Time) 0-100 Sets the time from when the Input level exceeds the
threshold level to when the effect begins to apply.
Release (Release Time) 0-100 Sets the time from when the Input level drops below the
threshold level to when the effect ceases to apply.
Ratio (Ratio) 1.5:1,2:1,4:1,100:1 Sets the compression ratio applied when threshold level
(Thresh) is exceeded.
ise Suppressor):
NoiseSup (Switch)
Mutes noise in the silent mode.
On, Off Turns the noise suppressor on or off.
Detect (Detect In) A, B, Link Selects the Input (Input /VInput B) for controlling Noise
Suppressor. Set this to “Link” for controlling by the input at
a greater level.
Thresh (Threshold) 0-100 Sets the level to start muting noise.
Release (Release) 0-100 Sets the time over which the volume will drop to 0 after the
noise starts being muted.
51