Roland VS-890 - Manual (Page 65)

Algorithm List
Vocal Canceler
when a stereo source is being input from CD or DA T and so on, this cancels the sound which is located in the
stereo center, such as the vocal or bass.
Depending on the music source, sounds that you do not wish to be canceled may be canceled as well. In
particular if the musical source has heavy reverb or if the sound that you wish to delete is not located in the
center, the vocal canceler may not produce the desired result.
Canceling the vocals alone
Vocal Canceler cancels the sound located in the center. That means it cancels sounds such as the bass and sounds
of the lead instrument along with vocal sounds. To cancel vocals only to create music for karaoke, for example,
set Range Lo to aroimd 100 Hz and Range Hi to around 1 kHz.
Parameter (full name) Setting Function
VC (Vocai Canceier):
VcICancel (Switch)
Cancels sounds located in the center such as vocals and the bass.
On, Off Turns the vocal canceler on or off.
Balance (Balance) 0-100 If the sound that you wish to cancel is not located in the
center, find the point at which it is most effectively cancelled.
RngL (Range Low) Unlimit, 20 - 2000 Hz Sets the lower limit of the frequency band to be canceled.
*1
RngH (Range High) 1.0-20.0 kHz, Unlimit Sets the upper limit of the frequency band to be canceled.
•2
ualizer)
EQ (Switch) On, Off Turns the equalizer on or off.
LowType (Low Type) Shiv, Peak Sets the type of the low frequency band equalizer
(Shiving type or peaking type).
Low.G (Low Gain) -12-+12dB Sets the boost/cut amount in the low frequency band.
Low.F (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low.Q (Low Q) 0.3-10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings. 1 *3
Mid.G (Middle Gain) -12-+12dB Sets the boost/cut amount in the middle frequency band.
Mid.F (Middle Frequency) 200-8000 Hz Sets the center frequency in the middle frequency band.
Mid.Q (Middle Q) 0.3-10.0 Sets the width of the area around the middle trequency that
will be affected by the gain settings.
Hi Type (High Type) Shiv, Peak Sets the type of the high frequency band equalizer (Shiving
type or peaking type).
Hi.G (High Gain) -12-+12dB Sets the boost/cut amount in the high frequency band.
Hi.F (High Frequency) 1.4-20.0 kHz Sets the center frequency in the high frequency band.
Hi.Q (High Q) 0.3-10.0 Sets the width of the area around the high trequency that
will be affected by the gain settings.1 *3
Out Level (Output Level) 0-100 Sets the volume after passing through the equalizer.
65