Roland VS-890 - Manual (Page 46)

Algorithm List
Parameter (full name) Setting Function
NS (Noise Suppressor):
NoiseSup (Switch)
Mutes noise in the silent mode.
On, Off Turns the noise suppressor on or off.
Thresh (Threshold)
0-100
Sets the level to start muting noise.
Release (Release) 0-100 Sets the time over which the volume will drop to 0 after the
noise starts being muted.
AMP (Pre-Amplifier):
PreAmp (Switch)
Simulates the pre-amplifier section of a guitar amplifier.
On, Off Turns the compressor on or off.
AMP (Pre-amplifier type) See the column on
the previous page.
Sets the type of the guitar amplifier.
Volume (Volume)
0-100
Sets the volume and degree of distortion of the amplifier.
Master (Master)
0-100
Sets the volume of the entire pre-amplifier
Gain (Gain) Low, Middle, High Sets the degree of sound distortion on the pre-amplifier.
Bass (Bass)
0-100
Sets the tone of the low range.
Middle (Middle) 0-100 Sets the tone of the middle range. *2
Treble (Treble) 0-100 Sets the tone of the high range.
Presence (Presence) 0-100 (- 100 - 0 ) Sets the tone of the ultra-high range. *3
Bright (Bright) On, Off You can set this on to generate clear-cut bright sounds. * 1
SP (Speaker Simulator):
Speaker (Switch)
Simulates a speaker.
On. Off Turns the speaker simulator on or off.
SP (Speaker Type) See the column on
the previous page.
Sets the speaker type.
Mic Setting (Microphone Setting) 1,2,3 Sets the location of the microphone that is recording the
sound of the speaker.This can be adjusted in three steps,
with the microphone becoming more distant in the order of
1, 2, and 3.
Mic Level (Microphone Level)
0-100
Sets the microphone volume.
DiLevel (Direct Level) 0-100 Sets the volume of the direct sound.
*1: Can be set only when JC-120, Clean Twin or BG Lead is selected for Pre-amplifier Type.
*2: Cannot be set when Match Drive is .selected for the Pre-amplifier Type.
*3: The setting range is -100 to 0 when Match Drive is selected for the Pre-amplifier Type.
46