Roland VS-890 - Manual (Page 43)

Algorithm List
EQ (Equalizer)
EQ (Switch) On, Off Turns the equalizer on or off.
LowType (Low Type) Shiv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Low.G (Low Gain) -12-+12dB Sets the boost/cut amount in the low frequency band.
Low.F (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low.Q (Low Q) 0.3-10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *1
Mid.G (Middle Gain) -12-+12dB Sets the boost/cut amount in the middle frequency band.
Mid.F (Middle Frequency) 200-8000 Hz Sets the center frequency in the middle frequency band.
Mid.Q (Middle Q) 0.3-10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Hi Type (High Type) Shiv, Peak Sets the type of the high frequency band equalizer (Shlving
type or peaking type).
Hi.G (High Gain) -12-+12dB Sets the boost/cut amount in the high frequency band.
Hi.F (High Frequency) 1.4-20.0 kHz Sets the center frequency in the high frequency band.
Hi.Q (High Q) 0.3-10.0 Sets the width of the area around the high frequency that
will be affected by the gain settings.1 *1
Out Level (Output Level) 0-100 Sets the volume after passing through the equalizer.
ch Shifter): Shifts the pitch.
P.Shifter (Switch) On, Off Turns the pitch shifter on or off.
C.Pitch (Chromatic Pitch) -12-12 Pitch variation (by semitone)
F.Pitch (Fine Pitch) -100-100 Pitch variation (by cent)
EFLevel (Effect Level) -100-100 Sets the volume of the pitch shift sound.
DiLevel (Direct Level) -100-100 Sets the volume of the direct sound.
DLY(Delay):Adds a delayed sound to the direct sound, adding depth to the sound or creating special effects.
Delay (Switch) On. Off Turns the delay on or off.
Time (Delay Time) 0-1000 ms Sets the time from direct sound until when the delay sound
is heard.
FBLevel (Feedback Level) -100-100 Sets the amount of the delay sound should be returned to
the delay input.
EFLevel (Effect Level) -100-100 Sets the volume of the delay sound.
DiLevel (Direct Level) -100-100 Sets the volume of the direct sound.
CHO (Chorus): Adds spaciousness and thickness to the sound.
Chorus (Switch) On, Off Turns the chorus on or off.
Rate (Rate) 0.1-10.0 Hz Sets the rate of modulation.
Depth (Depth) 0-100 Sets the depth of modulation.
EFLevel (Effect Level) -100-100 Sets the volume of the chorus sound.
DiLevel (Direct Level) -100-100 Sets the volume of the direct sound,
PreDLY (Pre-Delay) 0-50 ms Sets the time delay from when the direct sound begins until
the processed sound is heard.
*1: If Low Type (LowType) or High T)T3e (Hi Type) is set to "Shiv (Shlving Type)," the setting for LowQ or High Q
is invalid.
43