Roland VS-890 - Manual (Page 59)

Algorithm List
Parameter (full name) Setting Function
REV 2 (Reverb 2):
Reverb (Switch)
Gate reverb with two modes of gate operation
On, Off Turns the reverb on or off.
Type (Reverb Type) See the column on
the previous page.
Sets the reverb type.
Time (Reverb Time) 0.1-10.0 sec. Sets the length (time) of the reverb sound.
PreDLY (Pre-Delay) 0-200 ms Sets the time until the reverb sound is output.
Density (Density) 0-100 Sets the density of the reverb sound.
HPF (High Pass Filter) Thru, 20 - 2000 Hz Sets the frequency at which HPF starts taking effect.
Set this to “Thru" if HPF is to be disabled.
LPF (Low Pass Filter) 1.0-20.0 kHz, Thru Sets the frequency at which LPF starts taking effect.
Set this to “TTiru" if LPF is to be disabled.
EFLevel (Effect Level). 0-100 Sets the volume of the reverb sound.
DiLevel (Direct Level) 0-100 Sets the volume of the direct sound.
Gate (Gate) On, Off Opens or closes the gate.
Mode (Gate Mode) Gate, Ducking Sets the gate operation type.
Thresh (Threshold) 0-100 Sets the reference volume for controlling gate operations.
Attack (Attack) 1-100 Sets the time from when the direct sound level exceeds the
threshold level until when the gate is completely open.
Release (Release) 1-100 Sets the time from when the hold time has elapsed until the
sound is completely muted.
Gate Hold Time (Hold Time) 1-100 Sets the time from when the input falls below the threshold
level until when the release begins.
ualizer)
EQ (Switch) On, Off Turns the equalizer on or off.
LowType (LowType) Shiv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Low.G (Low Gain) -12-+12dB Sets the boost/cut amount in the low frequency band.
Low.F (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low.Q (Low Q) 0.3-10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *1
Mid.G (Middle Gain) -12-+12dB Sets the boost/cut amount in the middle frequency band.
Mid.F (Middle Frequency) 200-8000 Hz Sets the center frequency in the middle frequency band.
Mid.Q (Middle Q) 0.3-10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Hi Type (High Type) Shiv, Peak Sets the type of the high frequency band equalizer (Shlving
type or peaking type).
Hi.G (High Gain) -12-+12dB Sets the boost/cut amount in the high frequency band.
HI.F (High Frequency) 1.4-20.0 kHz Sets the center frequency in the high frequency band.
Hi.Q (High Q) 0.3-10.0 Sets the width of the area around the high frequency that
will be affected by the gain settings.1 *1
Out Level (Output Level) 0-100 Sets the volume after passing through the equalizer.
*1; If Low Type (LowType) or High Type (Hi Type) is set to "Shiv (Shlving Type)," the setting for LovvQ or High Q
is invalid.
59