Roland VS-890 - Manual (Page 53)

Algorithm List
Parameter (full name) Setting Function
Sate Reverb); Mutes the revert sound midway.
GtReverb (Switch) On. Off Turns the gate reverb on or off.
Time (Gate Time) 10-400 ms Sets the time from when the reverb sound begins until it is
muted.
PreDLY (Pre-Delay) 0-300 ms Sets the time until the reverb sound appears.
Mode (Gate Mode) See the column on
the previous page.
Defines how the reverb sound is applied.
EFLevel (Effect Level). -100-100 Sets the volume of the gate reverb sound.
DILevel (Direct Level) -100-100 Sets the volume of the direct sound.
Thick (Thickness) 0-100 Sets the thickness of the reverb sound.
Density (Density) 0-100 Sets the density of the reverb sound.
AcDLY (Accent Delay Time) 0-200 ms Sets the time from when the reverb sound is muted until the
accent sound appears.
AcLevel (Accent Level) 0-100 Sets the volume of the accent sound.
AcPan (Accent Pan) L63-R63 Sets the pan of the accent sound.
ualizer)
EQ (Switch) On, Off Turns the equalizer on or off.
LowType (Low Type) Shiv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Low.G (Low Gain) -12-+12dB Sets the boost/cut amount in the low frequency band.
Low.F (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low.Q (Low Q) 0.3-10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings. 1 *1
Mid.G (Middle Gain) -12--Hl2dB Sets the boost/cut amount in the middle frequency band.
Mid.F (Middle Frequency) 200-8000 Hz Sets the center frequency in the middle frequency band.
Mid.Q (Middle Q) 0.3-10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Hi Type (High Type) Shiv, Peak Sets the type of the high frequency band equalizer (Shlving
type or peaking type).
Hi.G (High Gain) -12-+12dB Sets the boost/cut amount in the high frequency band.
Hi.F (High Frequency) 1.4-20.0 kHz Sets the center frequency in the high frequency band.
Hi.Q (High Q) 0.3-10.0 Sets the width of the area around the high frequency that
will be affected by the gain settings.1 *1
Out Level (Output Level) 0-100 Sets the volume after passing through the equalizer.
*1: If Low Type (LowType) or High Type (Hi Type) is set to "Shiv (Shlving Type)," the setting for LowQ or High Q
is invalid.
53