AERCO BMK 2.0 LN Natural Gas (SN G-11-1861 and above) - Manual (Page 123)

GF-123
Benchmark 2.0LN Low NOx Boiler
Appendix D
OMM-0046_0E I nstallation, Operation and Maintenance Manual Reset Ratio Charts
PR1 08/20/12 AERCO International Inc.● 100 Oritani Dr. ● Blauvelt, NY 10913. ● Ph: 800-526-0288 Page 123 of 170
APPENDIX B: STARTUP, STATUS AND FAULT MESSAGES
Table B-1: Startup and Status Messages
MESSAGE DESCRIPTION
DEMAND DELAY
XX sec
Displayed if Demand Delay is active.
DISABLED
HH:MM pm, pm
MM/DD/YY
Displayed if ON/OFF switch is set to OFF. The display also shows
the time (am or pm) and date that the unit was disabled.
FLAME PROVEN
Displayed after flame has been detected for a period of 2 seconds.
Initially, the flame strength is shown in %. After 5 seconds has
elapsed, the time and date are shown in place of flame strength.
IGNITION TRIAL
XX sec Displayed during ignition trial of startup sequence. The duration of
cycle counts up in seconds.
PURGING
XX sec Displayed during the purge cycle during startup. The duration of
the purge cycle counts up in seconds.
STANDBY
Displayed when ON/OFF switch is in the ON position, but there is
no demand for heat. The time and date are also displayed.
WAIT Prompts the operator to wait.
WARMUP
XX sec
Displayed for 2 minutes during the initial warm-up only.