KEYENCE BL-180 - Manual (Page 65)

4.3 Command Communication
57
Setting Trigger Input (Starting Test Mode)
To set characters of the trigger on/Off command, send the following command.
Example 1: Change the trigger on command to S.
Function Command being sent
Respons
e
Description Error
Code
Setting signal type Change WP05n OK n= 0: Level
1: One-shot
00, 02
05, 07
14
Confirm RP05 05n
Setting one-shot input time Change WP42nnn OK nnn=001 to 225
(by 100 ms step) Confirm RP42 42nnn
Setting time constant of trig-
ger input Change WP04n OK n= 0: 2 ms
1: 10 ms Confirm RP04 04n
Setting state of trigger input Change WP03n OK n= 0: Normal-open
1: Normal-close Confirm RP03 03n
Starting test mode when trig-
ger input turns on.
(To specify the test mode, use
the command below.) Change WP06n OK
n= 0: Disable
1: Enable
Confirm RP06 06n
Specifying the test mode to be
started when trigger input
turns on. Change TRGTn OK
N= 1: Reading rate check mode
2: Tact check mode 00, 02
05, 08
14
Confirm TRGT TRGTn
Starting test mode when
power is turned on. Change TESTn OK n= 0: Reset
1: Reading rate check mode
2: Tact check mode
Confirm TEST TESTn
Setting characters of trigger
on command Change WP56hhh... OK hhh...=Trigger on command (Up to 8 characters)
* Specify characters in HEX (hexadecimal) code.
00, 02
05, 11
14
Confirm RP56 56hhh...
Setting characters of trigger
off command Change WP57hhh... OK hhh...=Trigger off command (Up to 8 characters)
* Specify characters in HEX (hexadecimal) code.
Confirm RP57 57hhh...
Note
WP5653CR
S
S=53h