KEYENCE BL-180 - Manual (Page 40)

3.3 Setup Software Operating Procedure
32
Example When the file name is “TEST”:
1. Click on the file name entry column.
2. Enter “TEST. CFG” as the file name .
3. Click on the OK button.
If you wish cancel this operation, click on the Cancel button.
To change the directory or drive, select a desired directory or drive in the
directory/drive selection column.
4. If the specified file name has already been stored, the following message will
appear.
To save the setting by overwriting the existing file, click on the OK button. If
you wish not to save the setting, click on the Cancel button.
Save A file name must be entered before the file can be saved
1. Click on Save . The file will be saved.
Exit 1. Click on Exit .
The following message appears.
2. To exit the setup software, click on the OK button. If you wish cancel, click on
Cancel .
Save the current settings before exiting the setup software.
3.3.2 Main setting screen
1. Place the mouse cursor at the item to be changed and click it, or move to the
target item by pressing [TAB] . Then, change the setting using [Space] .
2. To codes 1 to 4, specify the types of bar codes to be read.
If you specify 4 different types of bar codes, the BL-180 can read them with-
out changing the settings.
3. To set the code length or the inspect for check-digit, click Setup or press
[ENTER] to move to the setup screen for each code (see page 33 to 36).