KEYENCE DL-CL1 - Manual (Page 34)

3-2 Device Maps
3-6 - CC-Link Compatible Network Unit DL-CL1 User’s Manual (FD-S) -
Co
mm
u
ni
c
a
ting
w
ith t
he FD
-S
s
er
ie
s
3
Number [n] denotes the first relay number assigned to the DL-CL1.
*1 See "Entering an External Input into a Sensor Amplifier" (page 3-17).
*2 See "Reading Current Values (Instantaneous Flow Rate) from Sensor Amplifiers" (page 3-18).
*3 See "Reading/Writing Settings or Status of a Sensor Amplifier" (page 3-21).
See "Issuing a Motion Command to a Sensor Amplifier" (page 3-20).
Remote Register RWr (DL-CL1 -> Master Station)
Operating
mode
Device no.
(HEX)
Name
Communication
method
Description Writing range
Monitor mode
1
RY[n] + 40
to 43
(Not used) - - -
RY[n] + 4F
to 50
System reserved - Unusable
RY[n] + 51
Request for
command
*3
Used when communicating under handshake
control program.
This is input when requesting command
execution.
0->1: Request
execution
RY[n] + 52 System reserved - Unusable
RY[n] + 53
Current Value
Update Request
-
Used to lock data update in current value
boxes (RWr[n] + 08 to 0D).
This may be used to obtain the current values
of multiple sensor amplifi ers at the same
timing.
The comparator value is locked while the
update request is held.
The update lock state can be checked by the
current value update lock state (RX[n] + 53).
0: Do not lock
update
1: Request
update lock
RY[n] + 54
to 5D
System reserved - Unusable
RY[n] + 5E
Request to
change current
value page
*2
Used for reading the current value.
This is input when requesting to change the
current value page (the ID number of the
sensor amplifi er to read from).
0->1: Request
change
RY[n] + 5F System reserved - Unusable
RY[n] + 60
to 63
(Not used) - - -
RY[n] + 6F (Not used) - - -
Operating
mode
Device no.
(HEX)
Name
Communication
method
Description
Reading
range
S
mall-memor
y mode
1
S
mall-memor
y mode
2
Monitor mode
1
RWr[n] + 00 Error code -
Stores an error code when error state (RX[n] + 0F)
turns ON.
*4
RWr[n] + 01
Command
response
*3
Used for communicating under handshake control
program. Stores details of command execution result.
*5
RWr[n] + 02 to
03
(2 words)
Read data *3
Used when communicating under handshake control
program.
Stores the parameter data read from the sensor amplifi er.
*6