KEYENCE DL-CL1 User Manual
Page 15
1-3 Names and Functions of Each Part
1-5
1
B
e
fo
re
Usi
ng
- CC-Link Compatible Network Unit DL-CL1 User’s Manual (FD-S) -
* Not used with the FD-S series.
(3) Operating mode setting
switch
Sets the operating mode of the DL-CL1 in the CC-
Link. The specific data that can be communicated
using cyclic transfer varies with each operating
mode.
Default value: Small-memory mode 1
(4) Power indicator
When normal: Lit in green
For details, see
(5) Communication indicator
(6) Communication error
indicator
When normal: Not lit
For details, see
"Troubleshooting" (page 5-2).
(7) Sensor communication
indicator
When normal: Lit in green
For details, see
"Troubleshooting" (page 5-2).
(8) CC-Link connector
Attach the CC-Link cable to this connector.
DA/DB/DG
Communication signal
SLD
Connect the shielded wire of the CC-Link cable.
FG
Ground this functional ground terminal.
(Ground resistance: 100 ohm or less)
(9) Sensor amplifier connec-
tor (for DIN rail mounting)
Attach the sensor amplifier to this connector.
(10)Sensor amplifier
connector
(for panel mounting/large
display)*
Attach the sensor amplifier to this connector.
When shipped from the factory, a protective sticker
is installed.
The optional expansion cable (OP-35361) is used
for this connection.
Name
Description
Switch setting
Operating mode
Station
configuration
Number of link points
RX/R Y RW w/ RW r
Small-memory mode 1
(1-output, 1-input)
1-station, 1x
32
4
Small-memory mode 2
(3-output, 3-input)
64
8
Monitor mode 1
(5-output, 5-input, current value,
BANK change)
128
16
128
32
Full mode 1
(5-output, 5-input, current value,
BANK change, setting value change)
384
64
Others
Cannot be set
224
32
2-station, 1x
4-station, 1x
1-station, 8x
4-station, 2x
2-station, 8x
Monitor mode 2
(5-output, 5-input, current value,
BANK change)
Full mode 2
(5-output, 5-input, current value,
BANK change, setting value change)