Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 55)

Chapter 4 - Configuration
4-1
CHAPTER 4 - SYSTEM CONFIGURATION
Chapter Four covers procedures for configuring the HI 2151/30WC
Weight Controller. System Configuration includes only hardware
adjustments such as Jumper and Dip Switch settings. We recommend
that maintenance personnel be familiar with this chapter before config-
uring the weight controller. Alternative configuration procedures are
not recommended.
Standard RS-232C/RS422/
485 Configuration
Procedures.
About RS 232/RS422/
485 Bi-directional
Serial Ports (See
Chapter 5, for Setup
Procedures) The RS 232/RS422/485 Bi-directional serial ports are configured by
setting jumpers, dip switches and are also setup from the front panel.
The setup instructions are located in Chapter 5- System Setup Bi-direc-
tional Serial Ports. The jumpers and dip switches are located on the
Main board. (See Fig. 4-1)
FIG. 4-1 MAIN BOARD JUMPER AND DIP SWITCH LOCATIONS
Jumper Location
Dip Switch
Location