Cub Cadet 4 x 2 Big Country - Poly Bed & Steel Bed - Manual (Page 69)

4 X 2 Drive System - (Steel Bed)
65
12.6. Lift the reverse gear off of the intermediate shaft.
See Figure 12.6.
NOTE: The reverse gear has smaller O.D. and
larger I.D. than the forward gear.
NOTE: The recessed side faces the shift collar.
12.7. Lift the shift collar off of the intermediate shaft
together with the shift rod assembly. The pin on
the shift rod assembly should disengage from
the slot in the shift actuator as it is lifted out.
See Figure 12.7.
Figure 12.6
Intermediate
Reverse Gear
Shaft
Recessed
Side
Shift Collar
Figure 12.7
Pin
Shift Rod Assembly
Shift Actuator
12.8. Remove the intermediate shaft. See Figure 12.8.
12.9. Lift the forward gear out of the housing. The for-
ward gear has a smaller I.D. and a larger O.D.
than the reverse gear does. See Figure 12.9.
NOTE: The recess in the forward gear faces up,
toward the shift collar, the flat side faces the
housing.
12.10.Remove the thick (.110” thick) thrust washer
from case. It may sometimes remain stuck to the
forward gear, because of vacuum and oil adhe-
sion.
Figure 12.8
Intermediate Shaft
Forward Gear
(Recessed Side
Faces Shift Collar)
Figure 12.9
.110 Thick Thrust Washer