Cub Cadet 4 x 2 Big Country - Poly Bed & Steel Bed - Manual (Page 67)

4 X 2 Drive System - (Steel Bed)
63
11.4. Remove the detent set screw using a straight-
blade screwdriver. Retrieve the detent ball and
spring from the detent screw bore using a mag-
net. See Figure 11.4.
11.5. Position the housing differential lock side-up on
4x4 dimensional lumber, or a similar support.
See Figure 11.5.
11.6. Remove the perimeter bolts that fasten the two
housing halves together using a 3/8’ wrench and
a 7/16” wrench.
Figure 11.4
Magnet
Detent Ball and Spring
Figure 11.5
4X4’S
11.7. Use the square recessed pry-points to separate
the housing halves. See Figure 11.7.
11.8. Separate the differential lock housing from the
right side transaxle housing.
NOTE: The sealant is extremely tenacious.
11.9. Disengage the differential lock dog from the pin
on the differential lock shaft. Lift the dog out of
the housing and push the differential lock shaft
out of the differential lock housing.
See Figure 11.9.
11.10. Remove the two seals (axle shaft and differential
lock shaft) from the differential lock housing.
They will not be re-used.
11.11. Clean all sealant and lubricants from the hous-
ings.
Figure 11.7
Figure 11.9
Differential Lock Dog
Differential Lock Shaft
Differential Lock Housing