Cub Cadet 4 x 2 Big Country - Poly Bed & Steel Bed - Manual (Page 13)

Poly Bed 4 X 2 Drive System
9
4.40. Tighten the cable bracket mounting bolts to a
torque of 78 in-lb. (8.8 N-m) on installation.
4.41. The cable is secured to a bracket near the front
mounting point of the engine and transaxle cra-
dle. See Figure 4.41.
4.42. The cable is secured by two jam nuts that can be
removed using a 10 mm wrench.
4.43. Correct cable routing: cable mounted to right
side of bracket, then curved to the left to pass
beneath the air filter bracket.
4.44. Inspect the cable for wear or damage. Replace
it if there are any signs of fraying, binding, kink-
ing or damage to the cable housing.
4.45. Lubricate the cable with light oil (penetrating oil
or cable lube) any time it is removed, and at 500
hr. intervals when the gear lube is changed.
Figure 4.41
Note: cable routing
4.46. The clevis pin that holds the differential lock con-
trol lever to the frame cannot be removed with
the fuel tank secured in position.
See Figure 4.46.
4.47. The fuel tank bracket assembly can be removed
using 7/16” wrench. See Figure 4.47.
Figure 4.46
Move fuel tank
to remove pin
Figure 4.47