Cub Cadet 4 x 2 Big Country - Poly Bed & Steel Bed - Manual (Page 12)

Poly Bed 4 X 2 Drive System
8
4.34. If the linkage binds, disconnect the cable to iso-
late the external portion of the linkage from inter-
nal transaxle components.
4.35. Disconnect the differential lock control cable
from the differential lock control lever: Pull the
cable forward to get clearance to unhook the
spring at the end of the cable. See Figure 4.35.
4.36. There is sufficient slack in the cable to discon-
nect the barrel on the rear end of the cable from
the differential lock lever on the transaxle as
well: either end may be disconnected first.
See Figure 4.36.
4.37. With the cable disconnected, check the opera-
tion of the differential lock lever, and the torsion
spring that returns it to the unlocked position.
See Figure 4.37.
NOTE: Confirm that the torsion spring is prop-
erly positioned. Replacement of the torsion
spring with one that has a shorter leg was the
subject of Service Bulletin CC-456
4.38. The back of the cable is secured to the cable
holder by a pair of jam nuts: one on each side of
the cable holder. See Figure 4.38.
4.39. Depending on the nature of the repair, the cable
holder can be unbolted from the transaxle hous-
ing, or the rear jam nut can be removed and the
cable withdrawn from the holder. A 10mm
wrench will fit the jam nuts and the cable holder
bolts.
Figure 4.35
Figure 4.36
Disconnect barrel
from arm
Figure 4.37
Figure 4.38