Cub Cadet Fun Runner - Manual (Page 67)

4-51
HORN REMOVAL & INSTALLATION
STEP DETAILS
Make sure vehicle safe. Switch off and key out.
Parking brake set.
Adjust steering. Turn front wheels as far to the right as
possible.
Horn is accessible through right wheel well.
Disconnect horn (Figure 4-67). Remove spade connectors from tabs on horn.
Note that green wire is connected to positive
and black to negative terminals.
Remove horn from bracket (Figure 4-68). Reach between front bumper and horn
mounting bracket and unscrew front of horn
(by hand).
Pull horn out of bracket.
Place new horn in bracket. Insert rear part of horn in bracket and screw
front of horn onto rear. Tighten hand tight.
Connect horn wires. Slide connections onto terminals. Be sure
green wire is connected to positive terminal
and black wire to negative.
Test unit. Switch on and depress horn switch.