Cub Cadet Fun Runner - Manual (Page 116)

6-16
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
on one side or both
(other lights ok).
No voltage to lights.
Faulty controller.
Unplug connector at light harness front
or rear on affected side. Turn ignition
switch to on position and turn signal
light switch on. Check voltage at
harness connector: orange/black to
green for left side, orange to green for
right side. Should have pulsating 12
volts.
If voltage ok, check light harnesses and
bulbs. Repair or replace as needed.
If no voltage, check continuity of wires
to controller.
Light Harness Small Twist Lock
Connector Controller Connector
Orange/black wire to pin 8-left side
Orange wire to pin 7-right side
If no continuity, repair or replace wire
harness as needed.
If continuity, replace controller.
6-13