Cub Cadet Fun Runner - Manual (Page 39)

4-23
BATTERIES REMOVAL & INSTALLATION
STEP DETAILS
Make sure parts on hand. Batteries (total of 4 in vehicle)
Deka - “Dominator”
Model 8G24 - 12v
Get required tools. #2 Phillips screwdriver
5/8” wrench
9/16” wrench
1/2” ratchet wrench
Insulated pliers
3/16” Allen wrench
Make vehicle safe. Switch off and key removed.
Parking brake set.
Remove canopy assembly. If installed.
Remove utility bed. If installed.
4 Phillips screws.
Note: if utility bed not installed, lift storage
container from rear compartment.
Turn off master power switch. Located behind seat.
Remove rear body section (Figure 4-32) and
(Figure 4-33). 4 screws at front below seat.
Two screws each side beside seat.
Two screws below rear of seat (over battery).
4 screws around top of rear compartment
(same screws used to mount utility bed).
Lift rear body section and work it free. May
have to cut one or more electric tie wraps so
section can be lifted off without placing strain
on charger cable and plug.
Unplug charger power cable (Figure 4-34). Inside front of rear body section.
Press button on side of plug and disconnect.