Cub Cadet Fun Runner - Manual (Page 27)

4-11
Warning:
After axle assembly is completely loosened,
motor can fall and catch a hand unless care
is used. Suggest a block be placed under
differential bracket before axle is completely
loosened.
Disconnect motor support bracket
(Figure 4-11). Bolted to motor and frame on left side of
vehicle.
2 bolts, ¼” x ½” - need 3/8” wrench.
Remove axle mounting brackets
(Figure 4-12). Need ½” box end and ½” ratchet wrenches.
Slide axle assembly from under vehicle
(Figure 4-13). Attach lift to rear of frame, or use floor jack,
and raise vehicle high enough to slide rear
axle/motor assembly out to side.
Place supports under rear of battery pack to
be sure vehicle cannot fall.
Remove motor (Figure 4-14). Place support under motor.
Use 3/16” Allen wrench to remove two
mounting screws.
Tilt rear of motor down and remove from drive
axle.
Remove parts from motor. Slide coupler and speed sensor cog from
motor shaft.
Remove motor support bracket -two bolts -
3/8” wrench.
Loosen 1/8” Allen screw in end of spacer and
unscrew speed sensor.
Install parts on new motor (Figure 4-15). Bolt motor support bracket to new motor.
Insert speed sensor cog and coupler into
spacer and onto new motor shaft.
Install speed sensor in spacer.
Set speed sensor depth. Make sure speed sensor cog is inserted on
motor shaft
Screw speed sensor into spacer until it
touches cogs on sensor gear.
Unscrew speed sensor ¾ to 1 turn and make
sure it does not touch cogs when motor turns.
Tighten set screw to lock speed sensor in
place. Caution: do not over tighten set screw
causing damage to sensor threads.