Cub Cadet Fun Runner - Manual (Page 19)

4-3
SECTION 4: CANOPY INSTALLATION & REMOVAL
PARTS REQUIRED
710-0642 Hex Washer Screw 1/4-20 x .75 (8)
736-0342 Flat Washer .283 ID x .75 OD (12)
731-2337 Canopy Panel
749-1265 Rear Canopy Frame
749-1266 Front Canopy Frame
710-0136 Hex Cap Screw 1/4-20 x 1.75 (2)
710-1122 Hex Cap Screw 1/4-20 x 2.5 (2)
750-1298 Spacer .280 ID x 437 OD x .250 Lg (2)
750-1299 Spacer .280 ID x 437 OD x .850 Lg (2)
TOOLS REQUIRED
Phillips head screwdriver - #2
3/16” Allen wrench
Note: you may need one person to help.
STEP DETAILS
Get tools and check parts. See list above.
Assemble molded canopy and supports
(Figure 4-1). Align screw holes with holes in supports.
Install and tighten Hex washer screws with
flat washers through canopy into threaded
holes in supports.
Install canopy and support assembly.
Note: Nylon bushings are installed between
the vehicle body and the threaded screw
holes used to fasten the canopy supports.
Be careful to place bushings in position
properly.
Note: Screws have spacers under
canopy supports that must be installed to
protect body from deflection (Figure 1A).
Remove two cap plugs on top of body just
behind seating area.
Remove two Allen screws and spacers on
top of body directly in front of the dash.
Insert the shorter spacers in the front holes
and the longer spacers in the rear holes.
Gently set canopy/support assembly on
vehicle with curved end facing to the front.
(Figure 4-2).
Insert and tighten Hex cap screws with flat
washers in front and rear supports. Tighten
to 65 to 75 in. lbs. (Figure 4-3).
Save extra parts. Store Allen screws for use if top is removed.