Cub Cadet Fun Runner - Manual (Page 43)

4-27
Install rear body section. Lift body section and work into position so
screw holes are lined up.
Replace electrical tie wraps if necessary to
hold cables.
4 screws at front below seat.
Two screws each side beside seat.
Two screws below rear of seat (over battery).
4 screws around top of storage compartment
(leave out if utility bed to be mounted).
Turn on master power switch. Located behind seat.
Operate vehicle. Make sure all parts are operating properly.
Install utility bed. Make sure spacers are in position to prevent
warping rear body section.
Insert and tighten 4 mounting screws.
Install canopy assembly. If appropriate.
Lift assembly into position so canopy support
mounting holes line up with mounting screw
holes in body.
Install and tighten mounting screws (2 ½”
screws in rear support, 2” screws in front).
Charge battery pack. Plug in charger and charge battery pack
overnight to balance the battery modules.