Cub Cadet Fun Runner - Manual (Page 11)

2-5
will output a signal to the speedometer based on
an input from the speed sensor.
All of the controller inputs and outputs are
shown in Figure 2-11. The diagram shows how the controller is the master of the electrical
systems on the FunRunner.
Figure 2-11
Instrument Cluster
The instrument cluster has three indicator
gauges across the top and several LED
indicators along the bottom of the cluster. See
Figure 2-12. The cluster is the information
center for the operator.
Figure 2-12:
The center gauge is a speedometer with
odometer. The temperature gauge is on the left
and it displays the temperature of the controller
heat sink. The battery gauge is on the right side
and it displays the state of charge of the battery
pack.
The fault, temperature, battery, reverse, on,
high, low, charging, park brake, and headlights
indicators make up the bottom row of LED’s.
Above these indicator lights are the turn signal
indicators. These lights will illuminate when the
corresponding signal of its function is activated.
The fault, battery, charge, and temperature
indicators and an audible beep from the
controller are used to relay fault codes.