Cub Cadet Fun Runner - Manual (Page 23)

4-7
UTILITY BED INSTALLATION
PARTS REQUIRED
607-0013 Utility Box Assembly
710-1832 Machine Screw 1/4-20 x 2” (4)
736-0173 Flat Washer .28 ID x .74 OD (4)
TOOLS REQUIRED
#2 Phillips screwdriver
1/16” Allen wrench
STEP DETAILS
Remove rear trunk lid and trunk basket
(Figure 4-4). Raise cover so hinge rod is visible.
Loosen 1/16” Allen set screw on each hinge rod
locking collar.
Slide hinge rod toward one side to remove rod,
spacers and trunk lid.
Be careful not to loose spacers. Remove trunk
basket.
Remove body retaining screws
(Figure 4-5). Remove 4 Phillips head screws and washers
holding body to frame around storage area.
Disconnect trunk lock from back of vehicle by
removing the two cap screws.
Store screws for possible future use.
Install utility bed (Figure 4-6). Place bed on frame so tailgate is to the rear.
Line up holes in bed with holes in frame.
Install 4 screws and flat washers provided
through bed into frame.
Tighten screws to 40-45 in. lbs. and check bed
secure.
Clean up. Store parts and tools.