Cub Cadet Fun Runner - Manual (Page 53)

4-37
IGNITION SWITCH REMOVAL & INSTALLATION
STEP DETAILS
Make sure vehicle safe. Switch off and key removed.
Set parking brake.
Turn master power switch off (behind seat).
Warning:
Voltage is applied to the switch unless the
master power switch is off. Be careful.
Remove switch (Figure 5-50). Remove hex nut from switch at front of panel.
Pull switch out from rear of panel.
Unplug switch from jumper harness.
Install new switch (Figure 4-51). Plug into wiring harness.
Turn switch so key slot is oriented as desired
and insert switch through rear of panel.
Screw hex nut to front of switch until nut is
about the right position.
Adjust rear hex nut so switch is located at
right depth.
Tighten front nut.
Tie wrap excess wire so it is out of the way.
Turn master power switch on. Located behind seat.
Test unit. Make sure switch operates properly in all
positions.