Cub Cadet Fun Runner - Manual (Page 21)

4-5
Remove canopy assembly. Remove 4 Hex cap screws from supports and
set canopy assembly aside.
Remove spacers and store screws.
If canopy assembly is not to be replaced, place
cap plugs in rear body section and install
original Allen screws and spacers in front body
panel
Remove molded canopy.
Note: If canopy is to be re-installed, this step
is not necessary.
Remove 8 Phillips head, ¼” x ¾” screws from
canopy.
Lift canopy from supports and set aside.
Store screws for replacing canopy.