Brookfield DV2+Pro Viscometer - Manual (Page 68)

Brookfield Engineering Labs., Inc. Page 68 Manual No. M03-165-F0612
A.4 Verifying Calibration
1. Determine the appropriate sample volume. Refer to Table A-1 to determine the correct sample
volume required for the spindle to be utilized.
2. Select a Brookfield Viscosity Standard fluid that will give viscosity readings between 10% and
100% of full scale range. Refer to Appendix B for viscosity ranges of cone spindles.
Brookfield uses mineral oil viscosity standard fluids to calibrate Wells Brookfield Cone/Plate
Viscometers at the factory. Brookfield recommends that customers use mineral oil viscosity
standard fluids when you perform a calibration check.
If you decide to use a silicone viscosity standard fluid, do not use a fluid with a viscosity value
greater than 5000 cP with a Cone/Plate. Brookfield offers a complete range of mineral oil viscosity
standards suitable for use with Cone/Plates for viscosities above 5,000 cP or shear rates above
500 sec
-1
; see Table E-2 in Appendix E for a list of available fluids.
It is best to use a viscosity standard fluid that will be close to the maximum viscosity for a given
cone spindle/speed combination.
Example: LVDV-II+ Pro Viscometer, Cone Spindle CPA-42Z, Brookfield Silicone Viscosity
Standard having a viscosity of 9.7 cP at 25°C
At 60 RPM, the full scale viscosity range is 10.0 cP. Thus, the Viscometer reading should be
97% torque and 9.7 cP viscosity ± 0.197 cP. The allowable error (±0.197 cP) is a combination
of Viscometer accuracy and fluid tolerance (refer to Interpretation of Calibration Test Results
in Appendix E).
3. With the motor off, remove the sample cup and place the viscosity standard fluid into the cup.
Table A-1
Cone Part No.
CPA-40Z, CPE-40, CP-40
CPA-41Z, CPE-41, CP-41
CPA-42Z, CPE-42, CP-42
CPA-51Z, CPE-51, CP-51
CPA-52Z, CPE-52, CP-52
Sample Volume
0.5 mL
2.0 mL
1.0 mL
0.5 mL
0.5 mL
4. Attach the sample cup to the Viscometer and allow sufficient time for the sample, cup and cone
to reach temperature equilibrium.
5. Turn the motor on. Set the desired speed(s). Measure the viscosity and record the reading in
both % torque and centipoise (cP).
6. Verify that the viscosity reading is within the allowable 1% deviation, as explained earlier, for
the specific viscosity standard fluid(s) that you are using.
The CPE or CPA designation on the cone spindle indicates use with Electronic Gap Setting
Cone/Plate Viscometers/Rheometers only.