Brookfield DV2+Pro Viscometer - Manual (Page 30)

Brookfield Engineering Labs., Inc. Page 30 Manual No. M03-165-F0612
D°F(FAHRENHEIT)
DCGS UNITS
D°C(CENTIGRADE)
DCGS UNITS
"
Figure IV-5
To select the temperature display mode, press the
ENTER/AUTORANGE
key. You automatically exit
the Setup menu with the viscometer displaying temperature in the selected scale. You must press
the
ENTER/AUTORANGE
key to select the flashing option.
IV.2.2 Units of Measurement
Selecting units of measurement is identical to that for temperature described above. The screen
display shows:
D°F(FAHRENHEIT)
DCGS UNITSê
Figure IV-6
A press of the OPTIONS/TAB key at this point allows the user to “toggle” between the two
available data display units as shown in Figure IV-7:
D°F(FAHRENHEIT)
DCGS UNITS DF(FAHRENHEIT)
DSI UNITS "
É
Figure IV-7
Pressing the
ENTER/AUTORANGE
key selects the display units, which are flashing, followed by an
exit of the Setup menu. You must press the
ENTER/AUTORANGE
key to select the flashing option.
IV.2.3 Motor Speed Set Selection
This selection must be done with the motor off. Scrolling in the Setup options menu to the speed
set selection option yields the following screen display:
DCGS UNITS
DSEQUENTIAL
Figure IV-8
The last selected speed set option is displayed, in this case, Sequential. For each press of the
OPTIONS/TAB
key, the display shows selectable options (Figure IV-9). You must press the
ENTER/
#
$
#
$
#
$
#
$
#
$
#
$