Brookfield DV2+Pro Viscometer - Manual (Page 45)

Brookfield Engineering Labs., Inc. Page 45 Manual No. M03-165-F0612
Figure IV-2 shows the grid where the operator programs are created.
It is used to view and edit the B.E.V.I.S. programs. When the software
starts, an empty grid appears on the left of the screen. You can choose
up to 25 commands for your program. Highlight each command in
the list box to the right of this grid, then click on the Insert button to
insert that same command into the highlighted line of the grid. This
same insertion task can also be accomplished by double-clicking on
the appropriate command in the list box to the right.
In the case of a speed command (SSN), the Speeds list box becomes
enabled when the cursor is placed in the parameter column for an
SSN command. Click on the down arrow to display a list of available
speeds. Click on the desired speed, and it will be inserted into the
appropriate parameter column in the program grid. The same applies
to the spindle command (SSP).
The buttons shown on the main screen are explained below.
Select the COM (RS-232) port the Programmable DV-II+Pro Viscometer is connect-
ed to from the COM Port drop down list.
Click the Open File button to load existing B.E.V.I.S. programs.
Click the Save File button to save the B.E.V.I.S. program displayed in the grid.
Click the Print button to print the B.E.V.I.S. program displayed in the grid.
Click the Insert button to insert the B.E.V.I.S. command selected in the Commands box
into the selected row in the program grid.
Figure IV-2
1 SSN 50.0
2 WTI 00:30
3 SPI 00:05
4 WPT 75 .0
5 SSN 25.0
6 WTI 00:10
7 WPT 75 .0
8 SSN 0.0
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25