Welch Allyn LC101 CO2 Module - User Manual - Manual (Page 88)

LC101 CO
2
Module OEM Implementation Manual
Page 88 Confidential Welch Allyn OEM Technologies
Configure\ Display\CO2 Scale - The CO
2
waveform scale can be changed in the
Configure\Display\CO2 Scale menu item. The selections are listed below.
Configure\ Display\Gridlines - Horizontal gridlines on the waveform graph can be enabled by
checking the Gridlines menu item.
Configure\ Display\Waveform Fill - The Waveform Fill feature can be enabled by checking the
Waveform Fill menu item.
Configure\CO2 Module\Flow Rate - The CO
2
Module’s aspiration rate can be configured with
the Flow Rate menu item. The units are in milliliters per minute.
Configure\CO2 Module\CommPort - This menu item opens the following communications port
configuration screen.
NOTE The CO
2
Module supplied with the Evaluation System will be pre configured to match the PC
software’s default settings (Data Bits and Baud Rate), which are shown above. The CommPort
Assignment must be set to match the PC’s CommPort connected to the CO
2
Module during
initial setup.
The Help\About menu item displays the software title and version, copyright and a disclaimer.
The Help\Content menu item displays help information.
50 mmHg 6%
75 mmHg 10%
100 mmHg 14%