Welch Allyn LC101 CO2 Module - User Manual - Manual (Page 84)

LC101 CO
2
Module OEM Implementation Manual
Page 84 Confidential Welch Allyn OEM Technologies
Software Installation
To install this software on a Windows 95/98/NT computer, do the following:
1. Insert the CO
2
Monitor Windows Software CD into the computer’s CD-ROM drive.
2. Follow the screen instructions to install the software.
If the CO
2
Monitor software setup program does not start automatically, follow these steps:
Open My Computer, Windows Explorer, or File Manager.
Double click on the CD drive letter (usually D:,E:, or F:).
Double click Setup.exe.
Follow the screen instructions to install the software.
Initial Setup
To connect the hardware and start the program:
1. Plug the Serial Cable’s male connector into the 9 pin D-Type Serial jack on the back panel of
the CO
2
Module Evaluation Platform.
2. Plug the Serial Cable’s female connector into the Computer’s Serial Port 1 (CommPort 1).
3. With the Power Supply’s AC cord unplugged, connect the Power Supply’s other plug into the
power jack on the back of the CO
2
Module Evaluation Platform.
4. Plug the Power Supply’s AC cord into a 110 VAC wall outlet (or 220 VAC depending on
transformer configuration and available AC power).
5. At the computer, locate the CO2Mon Program directory created during the installation pro-
cess, and click on the CO2Mon icon to start the program.