Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 92)

88 820i Installation Manual
9.1.6 Batching Control Commands
The commands listed in Table 9-12 provide batching control through the serial port
Table 9-12. Batching Control Commands
Command Description Values
BATSTART Batch start If the BATRUN digital input is active (low) or not assigned, the BATSTART
command can be used to start the batch program.
BATSTOP Batch stop Stops the batch program and turns off all associated digital outputs.
BATPAUSE Batch pause Stops the batch program at the current step. All digital outputs set on by the
current step (except for those set by concur setpoints) are set off. The
BATSTRT DIGIN, BATSTART serial command, Batch Start softkey, or the
StartBatch function in an
iRite-IDE program can be used to restart the batch
program at the current step.
BATRESET Batch reset Stops the program and resets the batch program to the first batch step. Run
the BATRESET command after making changes to the batch configuration.