Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 16)

12
820i
Installation Manual
2.10 Replacement Parts and Assembly Drawings
Table 2-6 lists replacement parts for the 820i universal enclosure model, including all parts referenced in Figures
2-5 through 2-7. For assembly drawings and replacement parts information for the panel mount enclosures, see
the 820i Panel Mount Installation Instructions, PN 95304.
Table 2-6. Replacement Parts
Ref Number PN Description (Quantity) See Figure
1 93247 Switch panel membrane (1) 2-5
2 93618 Enclosure, universal (1)
3 102331 CPU board with single-channel A/D (1) 2-6
102333 CPU board with dual-channel A/D (1)
4 67532 Backplate gasket, universal (1)
5 68424 Enclosure backplate, universal (1)
6 75062 Sealing washers (4)*
7 14862 Machine screws, 8-32NC x 3/8 (4)*
8 14839 Machine screws, 6-32NC x 1/4 (3)
9 58248 Lock nuts, 6-32NC, nylon (2) 2-5
10 94392 Power supply bracket (1)
11 15628 Cord grip, 1/2 NPT (1)
12 15630 Lock nut for 1/2 NPT cord grip (1)
13 15626 Cord grips, PG9 (4)
14 15627 Lock nuts, PCN9 (4)
15 85202 Power cord assembly, 115 VAC and 230 VAC North American units (1)
85203 Power cord assembly, 230 VAC European units (1)
16 30375 Nylon seal rings for PG9 cord grips (4)
17 14822 Machine screws, 4-40NC x 1/4 (4)
18 67613 Power supply, ±6VDC, 25W (1)
19 42640 Setup switch access screw, 1/4 x 28NF x 1/4 (1)
20 44676 Sealing washer for setup switch access screw (1)
24 16861 High voltage warning label (1)
25 69291 3V Lithium coin battery 2-6
26 53308 Model/serial number label (1) 2-5
27 14626 Kep nuts, 8-32NC (3)*
28 15134 Lock washers, No. 8, Type A (3)
29 45043 Ground wire, 4 in w/ No. 8 eye connector (1) 2-7
30 67796 Power supply cable assembly, to CPU board (1) 2-5
31 53307 Label (1) 2-6
32 30376 Nylon seal ring for 1/2 NPT cord grip (1) 2-5
33 16892 Ground/Earth label (1) 2-7
— 67531 Tilt stand (1) —
— 93246 Display board assembly (1) —
* Additional parts included in parts kit.