Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 41)

Configuration 37
SOFTKEYS
Time/Date
Display Tare
Display Accum
Display ROC
Setpoint
Batch Start
Batch Stop
Batch Pause
Batch Reset
Weigh In
Weigh Out
Truck Regs
Unit ID
Select Scale
Diagnostics
Alibi
F1–F10 Use the Add and Remove softkeys to select softkeys to be displayed in weighing mode.
KYBDLK OFF
ON Keyboard lock. Specify ON to disable the keypad in normal mode.
ZERONLY OFF
ON Zero key only. Specify ON to disable all front panel keys except ZERO in normal mode.
PROMPTS PROMPT1–
PROMPT60 Specify prompts for use in setpoint names. Prompts are referenced by the NAME
parameter under the SETPTS submenus; prompts can be shown on the display during
setpoint execution.
REGULAT NTEP
CANADA
INDUST
NONE
OIML Regulatory mode. Specifies the regulatory agency having jurisdiction over the scale site.
• OIML, NTEP, and CANADA modes allow a tare to be acquired at any weight greater
than zero. NONE allows tares to be acquired at any weight value.
• OIML, NTEP, and CANADA modes allow a tare to be cleared only if the gross weight
is at no load. NONE allows tares to be cleared at any weight value.
• NTEP and OIML modes allow a new tare to be acquired even if a tare is already
present. In CANADA mode, the previous tare must be cleared before a new tare can
be acquired.
• NONE, NTEP and CANADA modes allow the scale to be zeroed in either gross or net
mode as long as the current weight is within the specified ZRANGE. In OIML mode,
the scale must be in gross mode before it can be zeroed; pressing the ZERO key in
net mode clears the tare.
• INDUST provides a set of subparameters to allow customization of tare, clear, and
print functions in non-legal-for-trade scale installations. See Level 4 parameter
descriptions in Table
3-9 on page 40.
The value specified for this parameter affects the function of the front panel TARE and
ZERO keys. See Section
10.2 on page 92 for a complete description of TARE and ZERO
key functions for each of the regulatory modes.
REGWORD GROSS
BRUTTO Sets the term displayed when weighing in gross mode. Selecting BRUTTO replaces the
Gross annunciator with Brutto.
CONTACT — Allows specification of contact information for use in iQUBE alert messages. See Level 3
submenu descriptions in Table 3-8 on page 39.
LOCALE OFF
ON Locale. Set this parameter ON to enable the LATUDE and ELEVAT parameters. Specifying
latitude and elevation of the scale site provides compensation for gravitational effects.
Attached scales must be recalibrated after changing this parameter from OFF to ON.
Note Gravitational compensation settings do not affect iQUBE scales.
FEATURE Menu
Parameter Choices Description
Table 3-7. FEATURE Menu Parameters (Continued)