Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 84)

80 820i Installation Manual
9.1.2 Reporting Commands
Reporting commands send specific information to the
serial port. The commands listed in Table 9-2 can be
used in either setup mode and normal mode.
9.1.3 Clear and Reset Commands
The following commands can be used to clear and
reset the
820i :
PCLR : Program clear. Erases the loaded user
program (setup mode only).
RS : Reset system. Resets the indicator without
resetting the configuration.
RESETCONFIGURATION : Restores all configuration
parameters to their default values (setup mode
only). The
RESETCONFIGURATION function can
also be initiated by pressing the Reset Config
softkey under the VERSION menu. Use the up
key to select Clear entire indicator configuration , then
press ENTER to reset the indicator.
All load cell calibration settings are lost when
the RESETCONFIGURATION command is run.
9.1.4 Parameter Setting Commands
Parameter setting commands allow you to display or
change the current value for a particular configuration
parameter (Tables 9-3 through 9-11).
Current configuration parameter settings can be
displayed in either setup mode or normal mode using
the following syntax:
command
Most parameter values can be changed in setup mode
only; setpoint parameters listed in Table 9-6 on
page 84 can be changed when in normal weighing
mode.
Use the following command syntax when changing
parameter values:
command=value , where value
is either a number or a parameter value. Use no spaces
before or after the equal (=) sign. If you type an
incorrect command, the display reads
?? .
For example, to set the motion band parameter on
Scale #1 to 5 divisions, type the following:
SC.MOTBAND#1=5
For parameters with selectable values, enter the
command and equal sign followed by a question
mark:
command=? to see a list of those values.
The indicator must be in setup mode to use this
function.
Some parameters are valid only if other
parameters or parameter values are specified.
See the configuration menus in Section 3.2 on
page 18 for information about parameter dependencies.
Restrictions for front-panel configuration also apply to
serial command configuration.
Command Function
DUMPALL List all parameter values
DUMPAUDIT List audit trail information
SPDUMP Print setpoint configuration
VERSION Write 820i software version
HARDWARE Lists installed option cards. See
Section 10.1.2 on page 90 for more
information about using the HARDWARE
command.
XE Returns a 10-digit code representing any
error conditions currently shown on the
front panel. See Section 10.1.4 on
page 91 for more information.
Table 9-2. Reporting Commands
Note
Note
Command Description Values
SC.GRADS#n Graduations 1–9999999
SC.SPLIT#n Multi-range or multi-interval scale type OFF, 2RNG, 3RNG, 2INTVL, 3INTVL
SC.ZTRKBND#n Zero track band 0, 0–100
SC.ZRANGE#n Zero range 1.900000, 0–100
SC.MOTBAND#n Motion band 1, 0–100
SC.SSTIME#n Standstill time 1–65535
SC.OVRLOAD#n Overload FS+2%, FS+1D, FS+9D, FS
SC.WMTTHRH#n Weighment threshold grads
SC.NUMWEIGH#n Number of weighments —
SC.MAX_WEIGHT#n Maximum weight —
SC.DIGFLTR1#n
SC.DIGFLTR2#n
SC.DIGFLTR3#n Digital filtering 1, 2, 4, 8, 16, 32, 64, 128, 256
Table 9-3. SCALES Serial Commands