ETS-Lindgren 2090 Controller - Manual (Page 7)

Model 2090 Multi-Device Controller
MODEL 2090 QUICK REFERENCE
Error List
Errors less than E100 can be cleared by pressing any key on the front panel to acknowledge the error. The
cause of the error condition should be corrected before continuing. The remaining errors may indicate that
the 2090 requires service. If one of these errors occurs, power off the unit for several seconds and power it
back on. If the error recurs, contact EMC Test Systems, L.P. for service.
E001 NVM Initialization Error – Parameters restored to factory defaults due to dead battery.
E002 Motor not moving – Device stalled due to overload, power problems, or failure.
E003 Device will not stop – Device continued moving for too long after motion was disabled.
E004 Device moving wrong direction – Device wired wrong, failing, or reverse delay too short.
E005 Hard Limit hit – Device has reached a mechanical limit.
E006 Polarization limits violation – Tower polarized outside allowed target polarization limits.
E007 Communication lost – No comm. w/ device; power off, fiber disconnected, or failure.
E008 Flotation violation – Attempt to disengage air flotation while turntable is in motion.
E009 Encoder failure – Detected changes in position consistent with an encoder problem.
E010 Trigger failure
E011 Overheat Error – Motor or control board over temperature
E012 Relay Failure – Motor drive control relays not switching properly
E100 ROM test error – ROM has been detected as being corrupt.
E101 RAM test error – RAM has been detected as being corrupt.
E102 NVM test error – NVM has been detected as being corrupt.
E103 Low Power test error – Power test failed.
E104 GPIB test error – GPIB test failed.
E996 BERR Error
E997 Uninitialized Interrupt
E998 Spurious Interrupt
E999 Invalid Interrupt Error
©ETS-Lindgren, April, 2006
Revision G – P#399199