ETS-Lindgren 2090 Controller User Manual

Page 53

Model 2090 Multi-Device Controller

SND

This is the sound configuration setting for the motorbase speaker.
The motorbase can output audible indications for errors, movement,
and remote control feedback. 0 = All sounds disabled, 1 = Key press
sounds enabled for hand control function, 2 = Error indications
enabled, 3 = Motion sounds enabled. With all sounds enabled the
motorbase will emit an audible noise if any error condition should
arise and a warning indication during movement.

Using the technique described previously, adjust the

necessary parameters so that they match the configuration

of the attached devices. Typical configurations are likely to

require adjusting parameters

, and

at a minimum.

Bore sight towers will also require the setting of parameter

to set the separation distance. The remaining

parameters are generally set to cover user preferences or

custom configurations.

NOTE: Do not change parameters of a device while

another device is in operation. Doing so will cause the

other device to stop motion.

Once the parameters have been configured for each device,

check and adjust the limits as necessary. Remember to

adjust the limits for both horizontal and vertical

polarizations on towers.

Revision G– P#399199