ETS-Lindgren 2090 Controller - Manual (Page 69)

Model 2090 Multi-Device Controller
USING AN AIR FLOTATION TURNTABLE
To configure an Air Flotation turntable do the
following:
Set P1 to 0 ; Define device as a turntable
Set P2 to 1 ; Air Floatation Turntable
The Air Flotation turntable works the same as a normal
turntable with one exception. This exception is the UP/
DOWN feature related to the Flotation. To prevent the
turntable from moving prior to the air being applied, the
Model 2090 automatically causes the air to raise the
turntable from the ground when a movement function is
given. A three second delay is provided to ensure that
turntable flotation has occurred prior to movement.
USING A REVERBERATION PADDLE
To configure a reverberation paddle do the following:
Set P1 to 0 ; Define device as a turntable
Set P2 to 0 ; Standard Turntable
Set P5 to 0 ; Continuous Rotation
Set C to appropriate calibration value. See the
section “Model 2090 Parameter List” for the
calibration value.
ETS-Lindgren reverberation paddles (mode stirrers/tuners)
operate similar to variable speed turntables, although they
typically have higher rotational speeds and are used in
continuous rotation mode.
©ETS-Lindgren, April 2006 69
Revision G– P#399199