ETS-Lindgren 2090 Controller - Manual (Page 57)

Model 2090 Multi-Device Controller
equipped with variable speed control) and then the STOP
motion indicator will illuminate for the Reverse Delay
period (see Parameter P8 ) before moving in the requested
direction. At that point, the UP/CW indicator will light
solid. In all cases, motion will continue until the device
reaches the soft limit, the hardware limit (if equipped), or
until another motion command is issued.
TO MOVE DOWN/COUNTERCLOCKWISE
To initiate continuous motion in the downward or
counterclockwise direction, press the DOWN/CCW key
under the POSITION key group. If the device is not
moving and is above the lower/counterclockwise software
limit (viewed by pressing the DOWN/CCW key in the
LIMIT group), the DOWN/CCW indicator will light and
the device will start moving in that direction. If the device
is already moving in the same direction, it will continue
moving to the lower/counterclockwise soft limit. If the
device is moving in the opposite direction, the
DOWN/CCW indicator light will flash to indicate that the
2090 has recognized the command. The device will
decelerate (if equipped with variable speed control) and
then the STOP motion indicator will illuminate for the
Reverse Delay period (see Parameter P8 ) before moving in
the requested direction. At that point, the DOWN/CCW
indicator will light solid. In all cases, motion will continue
until the device reaches the soft limit, the hardware limit (if
equipped), or until another motion command is issued.
©ETS-Lindgren, April 2006 57
Revision G– P#399199