ETS-Lindgren 2090 Controller - Manual (Page 42)

Initialization Model 2090 Multi-Device Controller
or activate specific controller functions. The edit behavior
of these parameters is described in the parameter table.
Using the LOCAL key to select the appropriate digit and
the INCRM and DECRM key to adjust the setting, any
value can be entered quickly. Once the desired value is
shown in the display, pressing ENTER will store the new
value. Pressing any key other than LOCAL, INCRM,
DECRM, or ENTER will exit the edit mode without
saving the value and perform the action associated with that
key.
When editing limits or the current position setting, the 2090
will not allow the current position to be set outside the
software limits, nor can the upper or lower limits be
adjusted below or above, respectively, the current position
or each other.
42 © ETS-Lindgren– April, 2006
Revision G– P# 399199