ETS-Lindgren 2090 Controller - Manual (Page 157)

Model 2090 Multi-Device Controller
APPENDIX C: MODEL 2090 ERROR
CODE REFERENCE
ERROR CODES
RECOVERABLE ERRORS:
dicate a recoverable problem that
cleared
otely through
e described in “GPIB
Status Reporting” under “Using the GPIB Command Set
E001
Battery Backup” in Appendix B:
for more information.
The following errors in
may require user intervention. These errors can be
by pressing any key on the front panel to acknowledge the
error. These errors can also be cleared rem
the GPIB Status reporting structur
with the Model 2090.
NVM Initialization Error. Parameter settings were lost
and restored to factory defaults. This error usually
indicates that the NVM backup batteries are dead and
should be replaced. See the procedure in the section
“NVRAM
Maintenance,
E002 Motor not moving.
E003 Device did not respond to stop Device Will Not Stop:
command.
E004 Device Moving In the Wrong Direction.
E005 Hard Limit: Device has reached a mechanical limit.
E006 Polarization limits violation.
E007 Communication lost.
E008 Flotation violation.
E009 Encoder failure.
E010 Trigger error.
E011 Overheat.
E012 Relay failure.
©ETS-Lindgren, April 2006 157
Revision G– P#399199