ETS-Lindgren 2090 Controller - Manual (Page 56)

Operation Model 2090 Multi-Device Controller
USING LOCAL FUNCTIONS
Pressing the LOCAL function key will cause the Model
2090 to exit remote mode, unless the unit has been
remotely set to the Remote With Lockout State (RWLS)
using the appropriate GPIB command codes (refer to the
documentation provided with the controlling GPIB device
for information on setting RWLS). When the controller
exits remote mode, it enters manual mode and remains
there until it receives the next GPIB command. Unless
given a GPIB command, the controller will automatically
be in the manual mode of operation. It is not possible to
enter remote mode by pressing the LOCAL key.
USING POSITION FUNCTIONS
While in manual mode, the POSITION keys control the
continuous motion of the attached device.
TO MOVE UP/CLOCKWISE
To initiate continuous motion in the upward or clockwise
direction, press the UP/CW key under the POSITION key
group. If the device is not moving and is below the
upper/clockwise software limit (viewed by pressing the
UP/CW key in the LIMIT group), the UP/CW indicator
will light and the device will start moving in that direction.
If the device is already moving in the same direction, it will
continue moving to the upper/clockwise soft limit. If the
device is moving in the opposite direction, the UP/CW
indicator light will flash to indicate that the 2090 has
recognized the command. The device will decelerate (if
56 © ETS-Lindgren– April, 2006
Revision G– P# 399199