HP 2566C - Manual (Page 86)

Power-On
Parameters and
Power-Fail Recovery
The HP2566C/HP2567C printer has no power fail indicator. When the
main power ON/OFF switch (hack of printer) is toggled “OFF” and
“ON” or a loss of power to the printer occurs, some of the printer’s
conriguration settings are retained in non-volatile memory, and some are
returned to defaults. (The numbers in parenthesis are configuration
functions. Refer to Table 5-1.)
Values Retained in
Printer Memory:
When power is restored to the printer, the following configuration
settings return to the same state as before the power-off condition:
c On/Off-line in the same state as before losing power
c Primary and Secondary Character Sets stay selected as configured
from the Operator Control Panel (1,2)*
■ Vertical Line Spacing (6/8 LPI) stays as selected from the Operator
Control Panel*
m Page Length representation as selected from the Operator Control
Panel (7)*
■ Interface Configuration (20-29)**
■ Enable/Disable Label Card (80)**
■ Printronix P-Series Linefeed Emulation (81)*
■ Graphics Horizontal Density (52)*
■ Perforation Skip (60)*
. Difficult Forms Mode (53)**
Values Returning to
Default State:
Following a power-off state, these printer functions revert to the
following conditions;
■ Paper moves to the next Top of Form position
Print buffer clears
_ Standard VFC channel assignments selected*
■ Left margin offset at zero*
■ Display functions off (61)*
*these conffguration settings do not affect printer communications but
may vary the appearance of printer output.
**these configuration settings affect printer communications and should
be verified anytime communication problems occur.
USING THE PRINTER 6-11