HP 2566C - Manual (Page 71)

All interface functions (20 - 29) and their parameters must be entered. If
you need to change the configuration or re-enter numbers, follow this
procedure:
1. Enter CONFIGURATION mode.
Make sure the printer is “off-line.” Press and hold down the
( config .)
key. At the same time, press either
( fine adj .)
keys to move to
the desired function (20 - 29). Two decimal points indicate the
CONFIGURATION mode.
2. Release the
( config .
1 key.
Find the parameter for the function (20 - 29) in the Interface manual
that was shipped with your printer, or if you wrote down the
configuration parameters when your interface was installed, use those
parameters.
3. Set the parameter.
Use either
( fine adj .1
key to move to the
desired parameter number.
4. Press
( enter
1
This sets the new parameter and the printer returns to the STATUS
mode.
5. Set the next parameter.
Repeat steps 1 through 4 until all the parameters for functions 20
through 29 are entered.
When selecting an HP-IB address, use the same basic procedure as
configuring other printer features such as character set selection and
print density. To select an HP-IB address, follow this procedure:
1. Enter CONFIGURATION mode.
Make sure the printer is “off-line.” Press and hold down the
( config .)
key. At the same time, press either
( fine adj .)
key to move to
function 20. The two decimal points indicate the CONFIGURATION
mode.
2. Release the
( config .)
key.
The current HP-IB address shows up in the display window.
3. Set the parameter.
Use the
( fine adj .
) keys to move to the desired address (0-7).
4. Press
( enter )
This sets the new address and the printer returns to the STATUS
mode.
5-6 PRINTER CONFIGURATION