HP 2566C - Manual (Page 81)

If a paper jam error occurs, press
( set t . o . f ,
1 then
( enter
) to clear
it. A “0” will show in the display window, however, the error will be
displayed again if the condition is not corrected before exiting the mode.
To clear a paper jam error, press the
( set t . o . f .
1 key. See “Adjusting
Top of Form” on page 3-30 for more information.
CONFIGURATION KEY:
(CONFIG.)
This key, in conjunction with the
( fine adj . 1
keys, lets you enter the
CONFIGURATION mode. The CONFIGURATION mode is where
you program the printer to perform various functions (interface
configuration, page length representation, select character sets, etc.).
Pressing the
( comfig 1
key alone will do nothing.
When the
( config .
1 key is held down, a function number is displayed.
This number can be changed by using either
( fine adj .)
key to move to a
new number. The middle and right decimal points light up to indicate
that you are in this mode. When the
( config .
] key is released, the
parameter associated with the function just displayed appears in the
display window. If you wish to change parameters, use either
( fine adj . )
key again to select a new parameter. Press
( enter
1 to store the
new
parameter and exit the CONFIGURATION mode.
If you do not want to change any parameter, press the
( config .
) key a
second time and the printer returns to the STATUS mode. You can also
press the
( on line )
key to return the printer to host control.
For more information on printer configuration, refer to page 5-1.
LPI ADJUST KEY:
( l . p . i . adj .)
Pressing this key shows the printer default LPI (lines-per-inch) setting
(6 or 8) in the display window. Since LPI is a function you can select,
two decimal points light up indicating you are in the CONFIGURATION
mode. Lines-per-inch can only be set to
6
or
8.
Press either
( fine adj . )
key to toggle between the two settings. When the desired setting is
displayed, press the [
enter
] key to store the value. If you do not want to
change the LPI setting, press
( enter )
to return to the STATUS mode or
the
( on line )
key to turn control over to the host. One additional note is
that this setting may be overridden by escape sequences. For more
information on setting LPI, refer to page 3-28.
TEST KEY:
Press this key to enter the TEST mode where you can select sub-tests
( test
) ^ check printer performance. To run a sub-test, press
( test
1, find the
desired sub-test with either
[ fine adj .
1 key, and then press
( enter ).
The sub-test will begin to print. Test failure is indicated by a flashing
error number in the Operator Control Panel display window. A detailed
description of the test function is presented on page 5-7.
6-6 USING THE PRINTER