1 key. at the same time, press either, Release the, Key a second time, or press the – HP 2566C User Manual
Page 66: Key, or press the, Keys to move to the desired parameter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5
The HP2566C/HP2567C printer needs to be configured to perform
various functions. Follow the procedure below, to configure your printer
using the buttons on the Operator Control Panel.
Table 5-1 lists the configurable printer functions and their associated
numbers. Each function has two or more possible parameters that can
be selected as desired. Some of the functions can be set remotely via
escape (ESC) sequences. See the HP256X Printer Family Technical
Reference Manual, 02564-90905, for information about remote
configuration. Also, use the Operator Information label, inside your
printer, as a quick reference guide for the CONFIGURATION modes.
Follow steps 1 - 4 to atyust and set CONFIGURATION modes from the
Operator Control Panel.
1. Enter the CONFIGURATION mode.
Make sure the printer is “off-line.” Press and hold down the
(CONFIG.
1 key. At the same time, press either
(
fine
adj
. ) key
to
move
to the desired function number (two decimal points indicate the
CONFIGURATION mode).
2.
Release the
(
config
.1 key.
The parameter value for the desired function number shows up in
the display window.
If you do not want to change the parameter, press the
(
config
.
) key a
second time, or press the
[
enter
) key, or press the
(
on
line
]
key. All
these retain the original configuration for that function.
3. Set the parameter.
Use the
(
fine
adj
) keys to move to the desired parameter.
PRINTER CONFIGURATION 5-1