HP 2566C - Manual (Page 49)

With perf skip “OFF,” the printer will print whatever number you enter
for physical text lines-per-page. If the number exceeds the maximum
physical lines the printer can print per page, it will print in the perf skip
region.
For more information on perf skip, refer to the section on “Perforation
Skip Mode” in the HP256X Printer Family Technical Reference Manual,
02564-90905.
Note
Perf skip mode is only applicable when using line feed instruction
“ applications fline count). If the application uses calls to Vertical Forms
Control (VFC) channels, the VFC definition
Of
vertical margin is used
and the state of the perf skip mode has no effect.
Set LPI (lines-per-inch).
Once you have determined the perf skip mode, the next step is to set
LPI.
1. Press
(L.P.I. ADJ.l
The present LPI setting shows up in the display window (the decimal
points indicate the CONFIGURATION mode).
2. Change the LPI setting.
If you want to change the value, use either
[ fine adj .
) key to move to
the desired LPI setting (both keys toggle between 6 and 8). If you
do not want to change the value, press the
fu.P.i. adj .)
key again to
return to the STATUS mode (a “0” appears in the display window)
and proceed to set the forms Ic/igth.
3. Press
[ enter ]
The printer returns to the STATUS mode (a “0” appears in the
display window) indicating that the desired setting is entered.
3-28 PREPARING THE PRINTER FOR OPERATION