HP 2566C - Manual (Page 83)

PRINT 1 LINE KEY:
( print 1 LINE 1
This key prints one line of data on the installed form at the current line
position. If you hold down the key, the printer prints continuous lines of
data.
I If you print a single line and want to look at it, press the line feed key to
advance the paper so that the line is visible. This is not necessary when
printing multiple lines.
The
( print 1 line !
key produces different data depending on the printer
mode. If the printer is in the TEST mode and you press
( print i line ),
status mode 7 displays and a test pattern prints that aid forms
alignment. If the printer is not in the TEST mode, the printer goes
“on-line” momentarily, displays status mode 6, prints one line of data,
then returns “off-line.” If no data is available from the interface or host
within 1 I seconds, the printer returns “off-line” vrithout printing.
FINE ADJUST
(UP/DN) KEYS:
( fine ADJ. 1
The two
( fine ADJ.
1 keys move the paper up or down in small
increments. When either key is held down, the printer keeps moving the
page until the key is released. The keys are also used to increment (up)
and decrement (down) the numbers in the display window when in the
TEST, CONFIGURATION, LPI Adjust and Page Length Adjust modes.
FORMS LOADING
CONTROLS
Vertical Paper Tension Lever
This lever (Figure 6-4, A) is used to make minor adjustments in
vertical paper tension by slightly changing the distance between the
upper and lower tractors. Moving the lever upward decreases paper
tension and moving the lever downward increases paper tension. This
control allows you to adjust the paper to move smoothly through the
tractors. For more information, refer to page 6-14, “Optimizing Print
Quality.”
Tractor Control Knob
This knob, located to the right of the tractors, controls which tractors
move when the tractor control keys are pressed (Figure 6-4, B). When
the knob is in the PRINT AND FORMS ALIGNMENT POSITION
(left), all four tractors can move. When the knob is set in the FORMS
WIDTH ADJUST POSITION (right), only the right tractors move.
6-8 USING THE PRINTER